Xerox 6100BD - Phaser Color Laser Printer Manual de iniciação - Página 30

Procurar online ou descarregar pdf Manual de iniciação para Servidor de impressão Xerox 6100BD - Phaser Color Laser Printer. Xerox 6100BD - Phaser Color Laser Printer 34 páginas. Disk overwrite installation and usage
Também para Xerox 6100BD - Phaser Color Laser Printer: Manual de instalação (34 páginas), Especificações (2 páginas), Manual do utilizador (32 páginas), Brochura e especificações (4 páginas), Manual do utilizador (28 páginas), Manual de instalação (2 páginas), Manual de Segurança (38 páginas), Manual de instalação (2 páginas), Nota de lançamento (2 páginas), Manual de iniciação (37 páginas), Manual (34 páginas), Manual (34 páginas), Manual do utilizador (32 páginas), Manual (11 páginas), Manual de instalação e operação (8 páginas)

Imprimir página
Xerox 6100BD - Phaser Color Laser Printer Manual de iniciação

TGBackup

26
TGBackup is an interim tape backup tool that supplements the
DocuSP System Backup utility. Backing up to tape in not yet
available in the Backup and Restore feature in DocuSP.
TGBackup provides the ability to backup the system files to a tape.
TGBackup is only available on a Sun SPARC workstation.
TGBackup is installed on the DocuSP controller by the Xerox
service representative. The TGBackup utility consists of the
following files:
♦ TGBackup.htm – these directions in html format.
♦ start_tgbackup – the TGBackup launch script
♦ run_tgbackup – the script used to invoke backup on a reboot of
the DocuSP
♦ tgbackup – the backup utility
♦ tg_checkswap – a script to check for and recreate the swap
space
♦ start_tgrestore – the recovery launch script
♦ tgrestore – the recovery utility
Performing a backup
To perform a backup perform the following steps:
Insert the TGBackup CD.
1.
Ensure the tape drive is connected and powered on. Insert a
2.
blank write-enabled tape cassette. If multiple tape drives are
on the system, make sure that only the drive you wish to use is
ready or online. TGBackup will use the first ready tape drive it
finds.
Open a terminal window and logon as root user.
3.
Enter the command cd /cdrom/cdrom0/TGBackup to
4.
change to the TGBackup directory.
Enter the command sh start_tgbackup to start the backup
5.
process; the script initiates a file system check then power the
printer off.
Power the printer back on. TGBackup interrupts the boot
6.
process, locates the tape drive and starts the backup to tape.
Once every ten minutes the screen updates with the
percentage of the job completed and an estimate of how much
more time is required to finish dumping the current file system.
A typical system being dumped to 4mm tape takes an average
of 2 hours.