Maintenance safety
Operational safety
Do c u Co lo r 50 0 0 G et ti n g Sta r te d
•
Do not attempt any maintenance procedure that is not
specifically described in the documentation supplied with your
product.
•
Do not use aerosol cleaners. The use of supplies that are not
approved may cause poor performance of the press and could
create a dangerous condition.
•
Use the supplies and cleaning materials only as directed in
this manual. Keep all materials out of the reach of children.
•
Do not remove the covers or guards that are fastened with
screws. There are no parts behind these covers that you can
maintain or service.
Do not perform any maintenance procedures unless you have
been trained to do them by a Xerox representative, or unless a
procedure is specifically described in one of the manuals included
with your press.
Your Xerox equipment and supplies were designed and tested to
meet strict safety requirements. These include safety agency
examination, approval, and compliance with established
environmental standards.
Your attention to the following safety guidelines will help ensure
the continued safe operation of your product:
•
Use the materials and supplies specifically designed for your
product. The use of unsuitable materials may result in poor
performance of the machine and possibly a hazardous
situation.
•
Follow all warnings and instructions that are marked on or
supplied with the machine.
•
Place the machine in a room that provides adequate space for
ventilation and servicing.
•
Place the machine on a level, solid surface (not on a thick pile
carpet) that has adequate strength to support the weight of the
machine.
•
Do not attempt to move the machine. A leveling device that
was lowered when your machine was installed may damage
the carpet or floor.
•
Do not set up the machine near a heat source.
•
Do not set up the machine in direct sunlight.
S a fe ty n o ti c e s
ix
Imprimir página