Alderon Industries VersAlarm 4X Manual de operação, manutenção e instalação
Procurar online ou descarregar pdf Manual de operação, manutenção e instalação para Sistema de segurança Alderon Industries VersAlarm 4X. Alderon Industries VersAlarm 4X 3 páginas. 2-zone outdoor
Também para Alderon Industries VersAlarm 4X: Manual de operação, manutenção e instalação (6 páginas)
Imprimir página
VersAlarm 4X
Indoor / Outdoor Alarm System
(auxiliary contact models)
Operation, Maintenance and Installation Manual
Introduction
Safety Guidelines
1. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE,
ETC. DO NOT USE IN EXPLOSIVE ATMOSPHERES.
2. DICONNECT ALL POWER WHEN INSTALLING, WORKING ON THE UNIT OR REPLACING THE FUSE.
3. FAILURE TO TURN OFF ALL POWER WHEN SERVICING THE VERSALARM™ 4X COULD RESULT IN
SERIOUS INJURY OR DEATH.
Description of Operation
The VersAlarm™ 4X is powered by 120VAC, "hard wired". When a float switch "closes" the buzzer and beacon will
turn "on".
Pressing the "Silence" button deactivates the buzzer and when the alarm is remedied, the system automatically
resets itself. The system can be tested be pressing the "Test" switch, when pressing the switch, the buzzer should
annunciate and the beacon should illuminate.
Electrical Information
Primary Power:
120VAC, 50/60 Hz
Watts:
10 Watts
Fuse:
1 Amp Fast Acting Type AGC
Buzzer:
95db @ 2 Feet
Switch:
UL Listed, 120VAC, 1 Amp Minimum
(signaling device)
Single Pole, Single Throw
Alarm Systems
Control Panels
PO Box 827 Hawley, MN 56549 (218) 483-3034 Fax (218) 483-3036 www.alderonind.com
Before proceeding with the installation or operation of the VersAlarm™ 4X, read all
instructions thoroughly, as well as complying with all Federal, State and Local Codes,
Regulations and Practices. The VersAlarm™ 4X must be installed by qualified personnel
familiar with all applicable local electrical and mechanical codes. Refer to the National
Electrical Code (NFPA 70). Failure to properly install and test this product can result in
personal injury or equipment malfunction.
The VersAlarm™ 4X is a multipurpose alarm that can be used in a wide variety of appli-
cations such as: septic tanks, sumps, holding tanks, pump chambers and water tanks.
Float Switches
Leak Detection Systems
QSG00269_Rev01
Page 1 of 2