Alderon Industries VertiMAC VM13 Series Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Interruptor Alderon Industries VertiMAC VM13 Series. Alderon Industries VertiMAC VM13 Series 20 páginas. Pump switch
Imprimir páginaIntroduction
The VertiMAC™ is a float operated pump switch, typically used in sump pump applications or situations where a regular pump
switch cannot operate due to limited space. The product comes with a pipe clamp bracket and stainless steel pipe clamp for
mounting to a pipe. Available in 120VAC or 240VAC, bare lead (no plug) or piggyback plug, 13 Amp models.
Safety Guidelines
Before proceeding with the installation or operation of this product, read all instructions thoroughly, as well as complying with
all federal, state and local codes, regulations, and practices. This product must be installed by qualified personnel familiar with
all applicable local electrical and mechanical codes. Refer to the National Electrical Code (NFPA 70). Failure to properly install
and test this product can result in personal injury or equipment malfunction.
1. DISCONNECT POWER when installing or servicing the product. Failure to disconnect all power sources could result in
serious injury or death.
2. NEVER enter a flooded space without proper Personal Protective Equipment (PPE). Always wear dielectric rubber boots
and other applicable protective equipment when water is on the floor and you must service an energized pump, alarm
system, or product.
3. DO NOT enter the water if the water level is higher than that of the protection your PPE offers or if your PPE is not
watertight.
4. DO NOT use this product with or near flammable liquids.
5. DO NOT install this product in locations classified as hazardous or in explosive atmospheres as defined by any applicable
electrical safety code.
VertiMAC™ Pump Switch - USER GUIDE
WARNING
Alderon Industries™ - Leading Edge Control Products | 3