CalGym CG-7515 Manual do Proprietário - Página 15

Procurar online ou descarregar pdf Manual do Proprietário para Equipamento de fitness CalGym CG-7515. CalGym CG-7515 20 páginas. Inner/outer thigh

Imprimir página

Item #

CAM

FLOATING PULLEY BRACKET

GUIDE ROD 3/4 RD X 48 1/4

INNER OUTER CABLE

SELECTOR PIN W/COIL 3/8 X 4 GOLD KNOB

TENSION CABLE

10 LB STEEL WEIGHT PLATE BLACK

10 LB TOP PLATE W/ADJUSTABLE SELECTOR BAR

WARNING:

CABLE BOLT (#80) MUST BE THREADED A MINIMUM OF 5/8" WITH REGULAR NUT AND SPLIT

WASHER TIGHTEN SECURELY TO ENSURE PROPER CONNECTION SEE FIGURES B AND C.

Weight stack label and lubrication instructions:

1. Wipe front surface of weight stack with rubbing alcohol and wipe dry.

2. Peel off back sheet (adhesive side) from label and make sure that the label remains

attached to the application tape.

3. Line up left edge of label sheet with outside edge of weight holes.

4. Line up the fi rst label to hole on top plate.

5. Make sure label is straight and slowly press into place.

6. Gently remove application tape and rub each label fi rmly against the weight stack.

7. Allow labels to stand for 2 days to allow adhesive to cure fully.

8. Open the lube package provided and apply a thin fi lm of lubricant around the fi rst 3 inches

of the guide rods above the top plate.

9. After the cables are installed, do a set of reps to spread the lubricant thoroughly.

Cable Adjustment

1. Adjustments can be made in the area pointed out (FIGURE B) to set the correct tension on

the cable.

2. Upon completion of assembly, the TOP PLATE (#24) does not sit on top of the fi rst WEIGHT

PLATE (#23), push the TOP PLATE (#24) down, insert the SELECTOR PIN (#17) and perform

several repetitions. This will self-adjust and re-align the cable system.

3. After completing the previous step, the TOP PLATE (#24) still does not sit on top of the fi rst

WEIGHT PLATE (#23) or if there is excess slack in the cable system, loosen regular nut (#42)

and adjust split hex tap bolt (#80) in/out to give the cable proper tension (taut). Once

achieving the proper tension, re-tighten regular nut (#42).

CG-7515 Inner/Outer Thigh

Step 5

Assembly List

Description

Qty.

Item #

LABEL-WEIGHT NUMBERS 1-20 DOTS Ø11/16

FINISHED HEX NUT Z/P 1/2 -13

NYLON INSERT LOCK NUT B/O 5/16-18

SHOULDER BOLT ALLOY 3/8 X 3/4

SPLIT BOLT GR-8 Z/P 1/2-13 X 1 (RND CUT)

SPLIT HEX TAP BOLT GR-8 Z/P 1/2 -13 X 3 1/2

SPLIT LOCK WASHER Z/P 1/2

BY TUFFSTUFF FITNESS

Description

Qty.