Yamaha YM-4900A Manual do Proprietário - Página 13

Procurar online ou descarregar pdf Manual do Proprietário para Instrumento musical Yamaha YM-4900A. Yamaha YM-4900A 14 páginas. Concert marimbas
Também para Yamaha YM-4900A: Manual do Proprietário (12 páginas), Manual do Proprietário (16 páginas)

Yamaha YM-4900A Manual do Proprietário
YM-4600A/4100A Only
5-2. As YM-4600A/4100A does not have a resonance regulator, insert resonators into resonator holders
as shown below.
* The resonators are factory adjusted so that the optimum resonance level is
obtained at 23°C. If desirable resonance is not available due to the
temperature lower or higher than 23°C, adjust setting of the resonators.
Move the resonators to fit into longer grooves when the temperature is higher
and into shorter grooves when the temperature is lower.
Temperature
Higher
Short groove
("A" in the figure right)
Around 23°C Center groove ("B")
Lower
Long groove ("C")
n
Adjust the height of the tone bars.
While supporting the frame end of the leg by hand, loosen the fixing bolt of the slide guide on both large
end and small end sides.
Adjust the height to the desired level and tighten the fixing bolts securely.
When adjusting the height, use the lines on the slide guide for reference and make the tone bars in
parallel with the floor surface.
Upon completion of assembly, check to make sure that each bolt is tightened securely.
Grooves to use
A : For a higher temperature
B : For a temperature around 23°C
C : For a lower temperature
Fixing bolt
ASSEMBLY
Resonator
holder
29