Yamaha Aventage RX-A1020 Manual de configuração fácil - Página 4
Procurar online ou descarregar pdf Manual de configuração fácil para Recetor Yamaha Aventage RX-A1020. Yamaha Aventage RX-A1020 19 páginas. Av receiver/receptor av
Também para Yamaha Aventage RX-A1020: Manual de configuração fácil (8 páginas), Especificações (2 páginas)
Imprimir página
3
Connecting speakers/subwoofer
• Under its default settings, the unit is configured for 8-ohm
speakers. When connecting 6-ohm speakers, set the unit's
speaker impedance to "6 Ω MIN". For details, see "Setting the
speaker impedance" in "Owner's Manual".
• Use a subwoofer equipped with built-in amplifier.
• Before connecting the speakers, remove the unit's power cable
from the AC wall outlet and turn off the subwoofer.
• Ensure that the core wires of the speaker cable do not touch
each other or come into contact with the unit's metal areas. This
may damage the unit or the speakers. If the speaker cables
short circuit, "Check SP Wires" will appear on the front display
when the unit is turned on.
■
Connecting speaker cables
Speaker cables have two wires. One is for connecting the
negative (–) terminals of the unit and the speaker, and the
other is for the positive (+) terminals. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminals.
a Remove approximately 10
mm (3/8") of insulation
+ (red)
b
from the ends of the
speaker cable and twist
the bare wires of the cable
firmly together.
– (black)
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China,
Banana plug
Australia and General
models only)
a Tighten the speaker
terminal.
b Insert a banana plug into the end of the terminal.
1
Connect the front speakers (1/2)
to the FRONT (//\) terminals.
The unit (rear)
FRONT
AUDIO
OUT
c
F R
O N
T
9
a a
d
4
a
F R
O N
T
b
SPEAKERS
SURROUND BACK/BI AMP
ZONE 2/PRESENCE
CENTER
SURROUND
SINGLE
EXTRA SP
SINGLE
CENTER
AC IN
ZONE 2
FRONT
SURROUND
SUR. BACK
1
SUBWOOFER
2
OUT
PRE OUT
1
2
3
5
2
Connect the center speaker (3) to the
CENTER terminal.
The unit (rear)
SPEAKERS
SURROUND BACK/BI AMP
FRONT
CENTER
SURROUND
SINGLE
SINGLE
CENTER
AUDIO
ZONE 2
FRONT
SURROUND
SUR. BACK
1
SUBWOOFER
2
OUT
OUT
PRE OUT
1
2
9
3
4
ZONE 2/PRESENCE
EXTRA SP
AC IN
5
3
En