Yamaha HTR-5920 Manual do Proprietário - Página 15

Procurar online ou descarregar pdf Manual do Proprietário para Recetor Yamaha HTR-5920. Yamaha HTR-5920 45 páginas. Digital home theater system av receiver
Também para Yamaha HTR-5920: Manual de serviço (38 páginas)

Imprimir página

Connecting speakers

Be sure to connect the left channel (L), right channel (R),

"+" (red) and "–" (black) properly. If the connections are

faulty, no sound will be heard from the speakers, and if the

polarity of the speaker connections is incorrect, the sound

will be unnatural and lack bass.

CAUTION

• Use speakers with the specified impedance

shown on the rear panel of this unit.

• Before connecting the speakers, make sure

that this unit is turned off.

• Do not let the bare speaker wires touch each

other or do not let them touch any metal part

of this unit. This could damage this unit and/or

speakers.

• Use magnetically shielded speakers. If this

type of speakers still creates the interference

with the monitor, place the speakers away

from the monitor.

Connecting to the SPEAKERS terminal

A speaker cord is actually a pair of insulated cables

running side by side. Cables are colored or shaped

differently, perhaps with a stripe, groove or ridges.

Connect the striped (grooved, etc.) cable to the "+" (red)

terminals of this unit and your speaker. Connect the plain

cable to the "–" (black) terminals.

Remove approximately 10 mm (3/8") of

insulation from the end of each speaker

cable and then twist the exposed wires of the

cable together to prevent short circuits.

10 mm (3/8")

Press and open the tab.

Red: positive (+)

Black: negative (–)

Insert one bare wire into the hole of each

terminal.

Release the tab to secure the wire.

Connecting to the SUBWOOFER

OUTPUT jack

If you do not use the YAMAHA SW-P170 subwoofer,

connect a subwoofer with a built-in amplifier.

Connect the input jack of your subwoofer to the

SUBWOOFER OUTPUT jack using the subwoofer

cable.

CONNECTIONS