Yamaha AP-U70 Manual de configuração - Página 18
Procurar online ou descarregar pdf Manual de configuração para Amplificador Yamaha AP-U70. Yamaha AP-U70 47 páginas. Personal amplifier
Também para Yamaha AP-U70: Manual de serviço (46 páginas)
INSTALLING USB DRIVER AND APPLICATION SOFTWARE
Macintosh computer
Connections and setup
1
Plug the AC power cord of this unit into the AC
outlet.
2
Start the Macintosh.
3
Connect this unit to a USB port on the computer
using the supplied USB cable.
The driver software for USB audio is automatically
installed.
4
Press the power switch of this unit to turn on this
unit.
Some messages are shown on the display.
Checking sound output and adjusting volume
USB
PC
AUX1
AUX2
VIRTUAL
5.I
CH
DIGITAL
USB PCM
D. DSP
PROLOGIC FM AM ST
VOL
DSP
M U T E
1
Make the following operations on the front panel of
this unit.
a) Press the USB input selector key.
b) Use the volume control to adjust the volume.
(Set the control to about "30".)
2
Check that the sound is output normally by
outputting "Alert Sounds", etc. from "Sound" on
the "Control Panels" on the Macintosh.
3
Adjust the volume by dragging the "Sound" tab on
the "Control Panels". Set the tab between the
center and max. position.
16
E-
USB
Display
Volume control
Power switch
Notes
● The sound output destination cannot be changed from
"Choose a device for sound output" on the "Control Panels".
When using the internal speaker of the Macintosh as the
sound output destination, disconnect the USB cable
connecting this unit and the Macintosh.
● When using headphones with this unit connected to the USB
port on the Macintosh, use the headphone jack on this unit,
not the jack on the Macintosh.
● Since the Macintosh issues a start-up sound at power-on
before the sound signal via the USB connection is activated,
the start-up sound cannot be issued via the USB connection.
To play the start-up sound via this unit, you need a separate
analog connection between this unit and the Macintosh.
(When USB MIX is set to "ON" from the Setup Panel of the
Application Software, you can mix the start-up sound via the
analog connection with the same sound via the USB
connection without making any change in the input selector
settings.)