Yamaha CX-1000 Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Yamaha CX-1000. Yamaha CX-1000 20 páginas. Natural sound stereo control amplifier
Também para Yamaha CX-1000: Manual do Proprietário (21 páginas), Manual do Proprietário (20 páginas), Manual de serviço (38 páginas)

Imprimir página

To help you distinguish between types of terminals at a glance, analog

audio jacks are black, digital (coaxial) audio jacks are green, and

video jacks are yellow.

The diagram on page 3 shows only the analog connections which

may be made to the CX-1000. Digital connections are shown in the

diagram below on page 4.

Make sure the left (L) and right (R) channels are connected consist-

ently between componenis.

NOTE:

Before making or altering any of the connections described beiow,

be sure to turn off all components.

Always check that

a) the RCA plug pins of any connecting cords are clean,

b) the digital pins of the optical fiber cords are clean too,

c) the left and right channels of all units are connected consistently,

and

d) connections are made securely.

Connect the OUTPUT1 (or OUTPUT2) jacks of the CX-1000 to the INPUT

jacks of your power amplifier.

TURNTABLE

Plug the turntable's output cords into the PHONO jacks. Partly un-

screw the CX-1000 GND screw terminal and connect the turntable's

ground wire, then tighten the screw. Grounding the turntable in this

manner usually produces the least hum. However, the ground wire

may be left disconnected if this gives better results.

CD PLAYER

Connect the output cords of your compact disc player to the CD jacks

a TUNER

Plug the cords from your tuner's output jacks into the the TUNER jacks

E DAT DECK

Connectthe LINE OUT (or equivalent) jacks of your Digital Audio Tap

deck to the TAPE1/DAT1

(or TAPE2/DAT2) IN jacks, and the deck's

LINE IN jacks to the TAPE1/DAT1

(or TAPE2/DAT2) OUT jacks.

TAPE DECK

Connect the LINE OUT jacks of the tape deck to the TAPES IN jacks

and the deck's LINE IN jacks to the TAPE3 OUT jacks.

E CDV PLAYER (or VDP)

Connect the L and R audio signal outputs ofa CDV or VDP (video dis

player) to the CDV1 (or CDV2) jack.

E VCRI/VCR2

Connections are basically the same as described above for a DAT

or analog tape deck - the stereo audio outputs of a video cassette

recorder are routed to the VCR1 (or VCR2) IN terminals, while the

VCR's audio inputs are connected to the OUT terminals.

CDV PLAYER

(or YDP)

Connect the video signal output of a CDV or VDP (video disc playe

to the VIDEO CDV1 (or CDV2) jack.