Yamaha ATS-1010 Manual do Proprietário - Página 13
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de altifalantes Yamaha ATS-1010. Yamaha ATS-1010 20 páginas. Front surround system
Também para Yamaha ATS-1010: Manual do Proprietário (19 páginas)
Imprimir página
Operation by the TV remote control is
difficult (with unit beneath/under TV)
TV remote control operation may be difficult if the unit
hides the sensor of your TV when beneath or under the
TV. Try the two solutions below and see whether this
solves the problem.
1 Move the unit in all directions.
2 Remove the stands to lower the height of
the unit.
Note
Keep the stands and screws in a safe place for future use.
Using TV remote control relay
function
If you cannot solve the problem by the suggestions above,
follow the procedure below and use the TV remote
control relay function, which relays the TV remote
control signal received at the front of the unit to the
remote control sensor of your TV through the TV remote
control signal transmitter at the rear of the unit.
TV remote control signal transmitter
1
Set the unit to standby mode.
Use a + driver to
remove the screws.
The unit will be
19 mm lower without
the stands.
The remote
control sensor of
your TV
2
Press both the VOLUME + button and
button of the main unit, release the
button first, then release the VOLUME +
button.
The unit is turned on when switching the TV remote
control relay function on/off.
The CLEAR VOICE indicator lights up as the
following illustration. Check if the setting is correct.
(☞ P. 11)
The CLEAR
VOICE indicator
(for 2 seconds
after the unit is
turned on)
No light
• The default setting is off.
• You can verify the current setting by turning the
unit on again from standby mode.
Notes
• Move the unit in all directions again if TV remote control
remains difficult.
• The TV remote control relay function is enabled even if
the unit is in standby mode.
Operate the unit by TV remote control
(TV remote control learning function)
You can use the TV remote control solely to operate by
having the unit learn the TV remote control operations.
You can operate the following functions by TV remote
control.
• Volume down
• Volume up
• Power on/standby mode
y
Some TV remote controls may not control these functions.
Use the remote control supplied with the unit in this case.
1
Set the unit and TV to standby mode.
2
Press both the INPUT button and
button of the main unit, release the
button first, then release the INPUT
button.
The unit enters the remote control
learning mode.
Continued to the next page. \
Additional Information
On
Off
Green
Flashes in
red
9
En