Ecoplus MAG DRIVE UTILITY PUMP 350 GPH Manual de instruções - Página 2
Procurar online ou descarregar pdf Manual de instruções para Bomba de água Ecoplus MAG DRIVE UTILITY PUMP 350 GPH. Ecoplus MAG DRIVE UTILITY PUMP 350 GPH 12 páginas.
Imprimir páginaThe following icons are used in the instruction manual:
WARNING! How to avoid personal hazard
DANGER! Avoid possible danger
CAUTION! Describes procedures you should follow to avoid damage to the
equipment or others.
WARNING!
Keep children away from this unit and do not let them play with the product.
DO NOT operate unit if persons are in water.
• A high-voltage connector is in the unit. Be sure to turn off the main power
supply prior to cleaning or performing any maintenance on the unit.
• Never cut the power plug and replace it yourself. This may lead to serious
injury or death.
• Never open the unit housing or its attendant components, unless this is explic-
itly required in the operation instructions.
Important Safety Instructions
For safety reasons children under the age of 16 and those not familiar with these
operating instructions are not permitted to use this unit.
DO NOT let children play with this appliance.
Electrical Precautions and Hazards:
• The combination of water and electricity can lead to death or severe injury from
electrocution if unit is incorrectly connected or misused.
• Prior to reaching into the water, ensure that the main power switch is off to all
units in the water.
• DO NOT operate if the cord or plug is damaged.
• DO NOT place product where it may fall down or get wet.
• DO NOT operate product during thunderstorms; it may result in electric shock.
• Install unit so that it is not exposed to direct sunlight. ( max. 100°F)
Drip Loop
A drip loops prevents the plug or electrical outflow from getting wet. A "drip loop"
shown in the figure on the next page, should be arranged for each cord connect-
ing the water pump to an electrical outflow. The "drip loop" is the part of the cord
below the level of the outflow or connector if an extension cord is used. A proper
"drip loop" should form a U shape in the cord. The "drip loop" prevents water from
traveling along the cord and coming into contact with the outflow.
Safety Instructions:
2