Directed Directechs DB3 Manual de instalação - Página 13

Imprimir página

Directed Directechs DB3 Manual de instalação

Soft reset

A module reset will only erase the steps perfomed in "Module Programming". The firmware and settings flashed to the module will not be

affected.

D2D installation

Connect the 10-pin, 12-pin & 14-pin harnesses to the module.

Press and hold the programming button, then connect the 4-pin D2D harness.

W2W installation

Connect the 10-pin & 12-pin harnesses to the module.

Press and hold the programming button, then connect the 14-pin harness to the module.

Wait 3 seconds until the LED turns ON solid orange then release the programming button.

The LED turns ON solid red.

Hard reset

Warning Against Executing a Hard Reset!

A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings may need to be

reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.

D2D installation

Connect the 10-pin, 12-pin & 14-pin harnesses to the module. Press and hold the

programming button, then connect the 4-pin D2D harness.

W2W installation

Connect the 10-pin & 12-pin harnesses to the module. Press and hold the programming

button, then connect the 14-pin harness to the module.

Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the LED starts

to flash orange and red.

Release the programming button. The LED turns ON solid red.

403.NISS06 3.27 2016 Nissan Rogue (Smart Key)

(D2D)

(Button)

(10-pin)

(Button)

(10-pin)

Solid

Release

(D2D)

(Button)

(10-pin)

(Button)

(10-pin)

Solid

Release

(12-pin)

(14-pin)

(12-pin)

(14-pin)

Solid

(12-pin)

(14-pin)

(12-pin)

(14-pin)

Flashes

Solid