Directed AS-3472TW Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Arrancador remoto Directed AS-3472TW. Directed AS-3472TW 20 páginas.

Imprimir página

WARNING: The vehicle is

not armed or locked down.

The Parking lights will flash

twice to indicate Ready

mode is set. To see the

icon,

refresh

remote screen by pressing

Remote-starting

Press the

The remote will beep once and the LCD will display "START".

The remote will confirm the remote starter's activation by beeping 3 times.

If your vehicle does not start on the first attempt, the system will shut down, wait a few seconds

and try to start the engine again. There will be 3 start attempts before the system gives up.

Driving Off

With the vehicle running remotely, press the

unlock the doors. Enter the vehicle and do the following:

Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK

position while the engine is running. This would cause the starter motor to re-engage.)

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will

shut the engine down. Please talk to your technician to determine if the "Takeover mode" can be

set for your vehicle.

Arming and disarming the starter kill (if installed)

This added security feature will prevent the vehicle from starting with the Ignition key when the

starter kill is armed. If the system was installed with the starter kill option, the vehicle will not be

able to start with the key unless the system has been unlocked first or put into Valet Mode

(page 12).

Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter motor

damage that could occur after remote-starting the engine should the user, by force of habit, turn

the ignition key to the CRANK position.

The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm

automatically) or Active Mode (so as to require the user's intervention for arming). By default, the

Remote Car Starter is configured to Passive Mode.

P.10

to unlock the doors and

shut down the engine;

to shut down the engine

without affecting the doors.

WARNING: Engine runs until the

pre-programmed

expires.

The

icon will appear on your

the

screen.

button for approximately 1 second and release.

interaction.

WARNING: Do not leave

run

time

your keys in the vehicle!

The Parking lights will flash

twice to indicate Ready mode

is set. To see the

refresh the remote screen by

pressing

button to disarm the starter kill (if installed) and

icon,

User Guide