Directed AS-RFK2300 Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Arrancador remoto Directed AS-RFK2300. Directed AS-RFK2300 8 páginas. Two-way fm led remote system
Imprimir página
Proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
Panic Mode
In an emergency situation, you can activate panic mode by pressing and holding the
button for more than 3 seconds, until the horn starts honking. If the vehicle is running
remotely, the engine will shutdown automatically before setting off the horn. You can stop the horn
by pressing:
(This will unlock your doors and deactivate panic mode).
Note: Panic Mode will automatically shut down after 30 sec.
Feature Confirmation Chart
Feature
Lock
Unlock
Trunk
Start
Running
Stop
AUX 1 & AUX 2
Note: These Auxiliary outputs can be used for many different applications
Sliding door(s):
These commands allow you to control most of the vehicle's accessories depending on what was
connected during the installation (headlights, defroster, sliding door, etc.). For more information,
check with your technician.
Vehicle Status Request
The status request feature allows the user to see the status of the vehicle i.e.: if the doors are
locked or unlocked, etc. The following charts indicate the confirmation sequences.
To retrieve the vehicle status:
Press and release the
The transmitter will then flash the sequence of LED's depending if the vehicle's doors are locked or
unlocked.
Status Request When the Engine IS NOT Running
STATUS
SEQUENCE
Lock
Unlock
P.6
button to lock the doors and to arm the OEM style alarm if available.
LED #1
LED #2
3 flashes
X
X
3 flashes
X
X
X
X
X
X
X
X
button then press and release the
LED #1
3 flashes
X
LED #3
X
X
3 flashes
X
X
X
LED #2
LED #3
X
X
3 flashes
X
LED #4
Beep(s)
X
X
X
3 flashes
3 flashes
3 flashes
button (there will be a beep).
LED #4
X
X
User Guide
button
1
2
1
1
3
2
Beep(s)
1
2