Clarke CCT48 Manual de Instruções de Operação e Manutenção - Página 8
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Ferramenta eléctrica Clarke CCT48. Clarke CCT48 13 páginas. Cordless tacker 6485070
Imprimir página
USING THE TACKER
1.
P
ay attention to the SAFETY WARNINGS in these operating instructions.
2. Press the tacker against the work and pull the trigger.
• Always hold the tacker square to the workpiece...Never at an angle.
3. Check that the nail or staple has
been driven into the workpiece.
• If it is protruding, increase the
impact force using the dial
shown.
• If it has been driven in too far,
decrease the impact force
using the dial shown.
• Check the result after each
adjustment.
• You should work at the lowest possible setting.
4. In the event of long breaks in work or at the end of the working shift,
remove the battery and empty the magazine.
TIPS
• Do not intentionally activate the tacker if the magazine is empty.
• Do not attempt to staple/nail at the edge of a workpiece, the edge
could fail, causing a nail or staple to shoot straight through.
TO CLEAR A JAM
Do not pull the trigger until the jam has been cleared, as this could cause
serious damage:
WARNING: REMOVE THE BATTERY FROM THE TACKER BEFORE CARRYING
OUT ANY SERVICING OR MAINTENANCE
1. Remove the battery from the tacker.
2. Release the magazine catch and slide the magazine open.
3. Remove all staples/nails from the chamber.
4. Using pliers, grip the jammed fastener and pull firmly to dislodge it.
5. Once the jammed fastener is removed, reload as above and continue.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8