Clarke CDP10B Instruções de funcionamento e manutenção - Página 13
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Ferramenta eléctrica Clarke CDP10B. Clarke CDP10B 19 páginas. 12 speed drill press
Imprimir página
OPERATION.
1 . Insert the drill bit into the jaws of the chuck by approx. 1", ensuring that the jaws do not
touch the flutes of the drill. Before tightening the chuck, ensure that the drill is centred
within the jaws.
2. Ensure the table height and position is set so that drill travel is sufficient for the job in hand.
3. Ensure the work is securely clamped or held in a drill vice, bolted to the table. Never hold it
with bare hands. Severe personal injury may be caused if the workpiece is whipped out of
the operator's hand and damage to the machine incurred if the work strikes the column.
If the piece is of irregular shape and cannot be laid flat on the table, it should be securely
blocked and clamped.
Any tilting, twisting or shifting, results not only in a rough hole but also increases drill breakage.
4. For small workpieces, that cannot be clamped to the table, use a Drill Press Vice which
must be clamped or bolted to the table.
5. If/when drilling completely through wood, always
position a piece of scrap wood between the
workpiece and the table to prevent splintering on the
underside of the workpiece as the drill breaks through.
The scrap piece of wood must make contact with the
left side of the column as shown in Fig 13.
In addition, set the depth of drill travel so that the drill
cannot possibly come into contact with the table, or
align the table so that the hole at its' centre is directly in
line with the drill bit.
6. When completely satisfied that the setup is sound,
lower the Chuck Guard and switch the machine ON by
pushing the GREEN 'I' button. To switch OFF...push the
RED 'O' button, see fig. 14.
In an emergency, hit the large round RED button on the
switch cover (arrowed in Fig 14)
If the cover is latched, open it by pushing the red
button upwards with the thumb
NOTE:
a. As a safety feature, the ON/OFF switch is a No Volt Release type. Therefore, if the power is
interrupted whilst the machine is switched ON, it will not automatically start when the power
is restored.
b. A Micro switch is provided within the Pulley Cover, which prevents the machine from
operating unless the Pulley Cover is firmly closed.
Drill Press Vices, Cross Vices and Clamps,
are available from your CLARKE dealer.
13
Fig. 13
Fig. 14