Clarke CHG2000C Instruções para o utilizador - Página 9

Procurar online ou descarregar pdf Instruções para o utilizador para Ferramenta eléctrica Clarke CHG2000C. Clarke CHG2000C 13 páginas. Hot air gun

• Normally only one pass is required to remove both thick and thin

layers of paint.

REMOVING PAINT FROM WINDOW FRAMES

DO NOT point the gun directly at

glass and always ensure it is

adequately protected. A glass

protection nozzle is provided for use

when stripping window frames etc.

1. Fit the glass protection nozzle to

the front of the hot air gun and

angle it so that the gun can be

placed up against the window,

with the cowl of the nozzle, flat

against the glass as shown.

2. It will be necessary to change the position of the protection nozzle as you

work around the window pane. Ensure you wear adequate hand

protection when doing so.

3. The protection nozzle must be kept in contact with the work at all times, but

do not spend too much time in one area.

When bending or forming plastic parts, work slowly and with great care

observing the effects of heat on such materials.

NOTE: With plastics, the temperature range between solid, pliable and

liquid states is narrow, therefore great care should be taken.

Wood can be stained giving a 'rustic' effect.

1. Fit the diffuser nozzle to the front of the hot air gun.

2. Do not hold the nozzle too close to the wood as this may cause the wood

to colour unevenly.

3. Use a fine sandpaper to remove any singed wood fibres when finished.

Fit the concentrating nozzle to the front of the hot air gun.

1. Select a suitable size heat shrink sleeve for the work piece.

2. Heat the sleeve evenly.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]