Clarke CHT879 Instruções para o utilizador - Página 3
Procurar online ou descarregar pdf Instruções para o utilizador para Ferramenta eléctrica Clarke CHT879. Clarke CHT879 4 páginas. Long/short arm threaded nut riveters
Imprimir página
FITTING THE MANDREL
1. Remove the sheath,
locking ring and washer.
2. Slide the spring-loaded
sleeve down to expose the
hex shank
3. Screw your chosen your
chosen mandrel into the
hex shank as far as possible.
4. Release the sleeve.
• The sleeve will spring back
over the lower part of the
mandrel.
5. Replace the sheath,
locking ring and washer.
6. Fit the mandrel nut, finger
tight, and tighten the locking ring.
SETTING THE STROKE
• Model CHT880 has a stroke scale
to help achieve optimum
compression of the rivet. The rivet
nut needs to shorten
approximately 6mm during
compression when using
M6,M8,M10 & M12 rivets. Smaller
rivets may require a smaller
setting.
1. Set the angle of the arms so that
the scale reads 6mm.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3