Clarke Contractor CON750 Manual de Instruções de Operação e Manutenção - Página 5
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Ferramenta eléctrica Clarke Contractor CON750. Clarke Contractor CON750 17 páginas. Contractor jigsaw
Também para Clarke Contractor CON750: Instruções de funcionamento e manutenção (20 páginas)
Imprimir página
f. Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
5) SERVICING
a. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
6) SPECIFIC WARNINGS FOR JIGSAWS
1. ONLY sharp saw blades in perfect working condition should be used;
cracked or bent saw blades should be discarded and replaced at once.
2. ALWAYS ensure that the blade is securely fixed.
3. ALWAYS use the appropriate blade for the material being cut.
4. ALWAYS use a cooling agent when cutting metals, i.e. cutting oil.
5. ALWAYS allow sufficient clearance beneath the work to ensure the blade
does not come into contact with the floor, table etc.
6. ALWAYS check for hidden electrical wires or water pipes etc.
7. ALWAYS keep the mains cable well away from the machine and ensure an
adequate electrical supply is close at hand so that the operation is not
restricted by the length of the cable.
8. When cutting wood, ensure any nails have been removed beforehand.
Nails will damage the wood saw blade.
9. NEVER allow the ventilation slots in the machine to become blocked.
10. NEVER attempt to stop the saw blade with your fingers.
11. NEVER put the saw down on a table or work bench unless switched off. The
saw blade will keep running briefly after the tool has been switched off.
12. DO NOT cut material above the specified thickness.
13. DO NOT cut through walls or cavities before checking for hidden electrical
wires or water pipes etc.
14. DO NOT touch the blade immediately after use, allow time for it to cool.
15. DO NOT attempt to saw extremely small workpieces.
16. Wherever possible, use clamps and vices to fasten the workpiece securely.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5