Clarke CONTRACTOR CON800 Instruções de funcionamento e manutenção - Página 8
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Ferramenta eléctrica Clarke CONTRACTOR CON800. Clarke CONTRACTOR CON800 17 páginas. 800w jigsaw with laser
Imprimir página
BEFORE USE
ADJUSTING THE CUTTING ANGLE
WARNING!
Before adjusting the cutting angle, make sure that the mains plug
has been removed from the mains supply.
1.
Loosen the base plate screws using
the hexagonal key provided.
See Fig 3
2.
Tilt the base to the required angle.
3.
There is a calibration plate on the
base plate to assist you in selecting
the correct angle. See Fig 4.
4.
Re-tighten the base plate screws to
secure the base plate.
You should double check the angle using a
protractor before use.
DUST EXTRACTION PORT ADAPTOR
This jigsaw has a dust extraction port to
enable you to connect it to a vacuum
cleaner. This will minimise the amount of
airborne dust generated during cutting.
To fit the dust extraction port adaptor:
1.
Push the dust extraction port adaptor
into the dust extraction port.
2.
Twist clockwise to secure into
position.
WARNING!
If the cutting operation is dusty, we recommend that you use a dust
mask.
Base plate
screws
Fig 3
Fig 4
8
Calibration
plate
Dust
extraction
port
adaptor
Fig 5