Zanussi ZBB28441SA Manual do utilizador - Página 10
Procurar online ou descarregar pdf Manual do utilizador para Frigorífico Zanussi ZBB28441SA. Zanussi ZBB28441SA 29 páginas. Zanussi zbb28441sa fridge-freezer user manual
Também para Zanussi ZBB28441SA: Manual do utilizador (16 páginas), Manual do utilizador (32 páginas), Manual do utilizador (49 páginas), Manual de início rápido (12 páginas)
Imprimir página
Problem
Water flows on the rear plate
of the refrigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
The appliance is equipped with a long-
life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
10
Possible cause
During the automatic de-
frosting process, frost melts
on the rear plate.
Food products prevent the
water to flow into the water
collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
1. With your fingers, spread slightly both sides of
the transparent cover to unhook them and
detach the cover pulling it in the direction of
the arrows.
Solution
This is correct.
Make sure that food products do
not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Add less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
CAUTION! Disconnect the plug from
the mains socket.