Directed Directechs DB3 Manual de instalação - Página 13

Imprimir página

Directed Directechs DB3 Manual de instalação

LED diagnostics and troubleshooting

This section provides LED diagnostics and troubleshooting information to guide you through the various stages of your installation.

Module Programming

LED

Description

Module has no power.

Off

Waiting to begin the programming

sequence.

Solid red

Initialization failed.

Flashes green & red

Transponder functions were skipped.

Solid orange

All required CAN networks has been

detected.

Flashes green

1 of 2 CAN networks has been detected.

Flashes orange

Key2GO initiated.

Flashes orange

slowly

Module was successfully programmed with

all functions.

Solid green x 3 secs

Module was successfully programmed

without transponder functions.

Solid orange x 3 secs

Module Programming - Error codes

LED

Description

CAN2 not detected.

Flashes red x 1

J1850 not detected.

Flashes red x 1

CAN1 not detected.

Flashes red x 2

Bypass data not detected.

Flashes red x 3

Bypass processing error.

Flashes red x 4

ISO 1 not detected.

Flashes red x 5

ISO 2 not detected.

Flashes red x 6

MUX not detected.

Flashes red x 7

External Module Synchronization

LED

Description

OBDII feature not supported.

(Flashes red, red,

then orange) x 10

403.KIA10 1.10 2023 Kia Carnival (Smart Key)

Troubleshooting

Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If

12 Volt is present, the module may be defective.

Ensure the correct programming procedure is being followed.

Reset the module and complete the programming again. If the issue persists, please contact Technical

Support.

(If compatible) when RXT mode is not desired or convenience features are needed, please reset the and

reprogram the module.

Normal operation.

Please follow the steps indicated in "Module programming" to complete the Key2GO programming.

Normal operation.

Troubleshooting

Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by

turning the ignition on and try again. If your installation does not require this connection, skip this step by

pressing the programming button 5 times.

Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.

Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on

and try again. If your installation does not require this connection, skip this step by pressing the

programming button 5 times.

Check the bypass line connection. If more than one wire is used, make sure they are not inverted. Ensure

the vehicle still operates correctly using the factory key.

The bypass calculation failed. Reset the module and try again. If the condition persists, please contact

Technical Support.

The Yellow/Black wire did not detect the expected signal. Refer to "Installation (wiring diagrams &

vehicle wiring reference charts)" on page "Installation (wiring diagrams & vehicle wiring reference

charts)" to check the connections.

The Orange/Black wire did not detect the expected signal. Refer to "Installation (wiring diagrams &

vehicle wiring reference charts)" to check the connections.

The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to "Installation

(wiring diagrams & vehicle wiring reference charts)" to check the connections.

Troubleshooting

The diagnostic data bus was not detected, therefore the SmartStart features will be limited.