Zanussi ZFC 22/1 L Folheto de instruções - Página 4
Procurar online ou descarregar pdf Folheto de instruções para Frigorífico Zanussi ZFC 22/1 L. Zanussi ZFC 22/1 L 10 páginas. Fridge-freezer zfc 22/1 l
Imprimir páginaINSTALLATION
If this appliance featuring magnetic door seals is to replace an
older appliance having a spring lock on the door or lid, be sure
to make that spring lock unusable before you discard the old
appliance. This will prevent it from becoming a death-trap for a
child.
Location
Place the appliance as far away as possible from
sources of heat, e.g. radiators, heaters, direct
sunlight, etc..
The best results are achieved with a room
temperature ranging from +18 C to +43 C (class T).
Make sure that there is nothing at the back, at the
top and at the bottom of the appliance to obstruct
air circulation.
For more efficient operation of the appliance the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any,
should be at least 15 mm (Fig. 1-A).
The best solution is shown in Fig. 1-B (without
overhanging kitchen furniture).
The appliance sides may also be in contact with the
kitchen furniture, provided that air can circulate
freely round the back and top.
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly
level.
A
D175
Fig. 1
B
Power connection
Before plugging the appliance into the mains socket,
check that the voltage and frequency indicated on
the appliance's rating plate are the same as those
provided by your home power supply.
A 6% fluctuation above or below rated voltage is
acceptable.
For operation at different voltages, a suitable
transformer should be used.
Make sure the plug and the socket are compatible so
that no adaptors need to be used. If necessary,
replace the socket with a suitable one.
The appliance MUST be connected to an efficient earth or
ground tap.
The supply-lead plug in fact incorporates a special
earth or ground contact for this purpose. If by any
chance the sockets of your domestic wiring system
are not earthed, the appliance must be connected to
a separate earth or ground wire by a qualified
electrician, in accordance with existing safety
regulations.
The manufacturer declines to accept any liability if this
accident-prevention procedure is not followed.
This appliance complies with the relevant UNI
standards and with E.E.C. Directive No. 87/308 of
02.06.87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the appliance's interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then dry thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
13