Zanussi ZI 5235 Folheto de instruções - Página 4

Procurar online ou descarregar pdf Folheto de instruções para Frigorífico Zanussi ZI 5235. Zanussi ZI 5235 8 páginas.
Também para Zanussi ZI 5235: Folheto de instruções (9 páginas)

Imprimir página

INSTALLATION

If this appliance featuring magnetic door seals is to

replace an older appliance having a spring lock (latch) on

the door or lid, be sure to make that spring lock

unusable before you discard the old appliance.

This will prevent it from becoming a death-trap for a

child.

Positioning

The appliance should be installed well away from sources

of heat such as radiators, boilers, direct sunlight etc.

Best performance is obtained with ambient

temperature between +18 C and +43 C (class T); +18 C

and +38 C (class ST); +16 C and +32 C (class N); +10 C

and +32 C (class SN).

The class of your appliance is shown on its rating plate.

For building into kitchen units follow the special

"Building-in" instructions given.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate correspond

to your domestic power supply.

Voltage can vary by 6% of the rated voltage.

For operation with different voltages, a suitably sized

auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a contact

for this purpose.

If the domestic power supply socket is not earthed,

connect the appliance to a separate earth in compliance

with current regulations, consulting a specialist

technician.

The Manufacturer declines all responsibility if the above

safety precautions are not observed.

This appliance complies with EEC directive number 87/308 of

2/6/87 relative to radio interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modiﬁcations.

Cleaning the interior

Before using the appliance for the ﬁrst time, wash the

interior and all internal accessories with lukewarm

water and some neutral soap so as to remove the typical

smell of a brand-new product, then dry thoroughly.

Do not use detergents or abrasive powders, as these

will damage the ﬁnish.

Instructions for totally built-in appliances

Dimensions of the recess

Height

1225 mm

Depth

550 mm

Width

560 mm

The appliance's door has been locked in position for

transport by means of pins on both sides. According to

the door opening direction, remove relevant pins at the

top and at the bottom.

For safety reasons, minimum ventilation must be as

shown in Fig. 1.

Attention: keep ventilation openings clear of obstruction.

50 mm

D567

D022

Fig. 1

min.

200

Fig. 2

Push appliance

into the housing

until stop strip

(A) touches the

kitchen unit.