Zanussi ZK 23 Folheto de instruções - Página 12

Procurar online ou descarregar pdf Folheto de instruções para Frigorífico Zanussi ZK 23. Zanussi ZK 23 14 páginas.
Também para Zanussi ZK 23: Folheto de instruções (10 páginas)

Imprimir página

Changing the opening direction of

the doors

Before carrying out any operations, remove the plug

from the power socket.

To change the opening direction of the door,

proceed as follows:

Before carrying out any operations, remove the plug

from the power socket.

To change the opening direction of the door,

proceed as follows:

1. pull off the ventilation grille (D) which is clipped

into place;

2. remove the bottom hinge (E) by unscrewing its

three fixing screws;

3. remove the lower door, sliding it out of the middle

hinge;

4. unscrew the middle hinge (H);

5. remove the upper door by releasing it from the

top hinge pin (G);

6. remove the pin then mount it on the opposite

side, after having removed the plugs which must

be refitted on the other side;

7. refit the fridge door. Replace the middle hinge to

the left hand side;

8. replace the freezer door;

9. using a 10 mm spanner, unscrew the hinge pin

(E) and reassemble it on the opposite side of the

hinge;

10.reassemble the lower hinge (E) on the opposite

side, using the screws previously removed. Slide

the hole cover (F) out of the ventilation grille (D)

by pushing it in the direction of the arrow and

reassemble it on the opposite side;

11. refit the ventilation grille (D), clipping it into place;

12.dismantle the handles and reassemble them on

the opposite side. Cover the holes left open with

the plugs contained in the documentation pack.

The doors can be aligned by adjusting the middle

hinge.

The middle hinge can be adjusted horizontally, with

the help of a tool, after having slackened the two

screws.

Warning:

After having reversed the opening direction of the

doors check that all the screws are properly

tightened and that the magnetic seal adheres to the

cabinet. If the ambient temperature is cold (i.e. in

Winter), the gasket may not fit perfectly to the

cabinet. In that case, wait for the natural fitting of the

gasket or accelerate this process by heating up the

part involved with a normal hairdrier.

PR18

PR220

D338

P R 1 8 9