Zanussi ZPC 726 D Folheto de instruções - Página 4

Procurar online ou descarregar pdf Folheto de instruções para Frigorífico Zanussi ZPC 726 D. Zanussi ZPC 726 D 9 páginas.

Imprimir página

If this appliance featuring magnetic door

seals is to replace an older appliance having

a spring lock (latch) on the door or lid, be

sure to make that spring lock unusable

before you discard the old appliance. This

will prevent it from becoming a death-trap

for a child.

Positioning

The appliance should be installed well away

from sources of heat such as radiators, boilers,

direct sunlight etc. Best performance is

obtained with ambient temperature between

+18°C and +43°C (class T); +18°C and +38°C

(class ST); +16°C and +32°C (class N); +10°C

and +32°C (class SN). The class of your

appliance is shown on its rating plate.

For building into kitchen units follow the special

" Building-in" instructions given.

Important

It is essential that the appliance be connected

to an efficient earth tap. For this purpose the

supply cable plug incorporates a special earth

contact. If the sockets of your domestic wiring

system are not earthed, have the appliance

connected to a separate earth wire by a

qualified electrician in accordance with existing

safety regulations.

The Manufacturer declines all responsibility

if the above safety precautions are not

observed.

This appliance complies with EEC directive

number 87/308 of 2/6/87 relative to radio

interference suppression.

This appliance complies with the

following E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage

Directive) and subsequent mod)fications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Cleaning the interior

Before using the appliance for the first time,

wash the interior and all internal accessories

with lukewarm water and some neutral soap so

as to remove the typical smell of a brand-new

product, then dry thoroughly. Do not use

INSTALLATION

detergents or abrasive powders, as these will

damage the finish.

Door reversibility

This appliance is equipped to allow the opening

direction of the doors to be changed. To do this:

Position the appliance horizontally.

Unscrew the middle hinge (A) and remove it,

slightly lifting the doors.

Remove the top door, unscrew the top screw (1)

and remove it with its washèr (2).

Remove the stud (3) and fit it on the opposite

side using screw (1) and its washer (2).

Reposition the door.

Remove the bottom door. Remove the three

screws (5) which secure the hinge to the

cabine". Slowly sfide the hinge out of the slot in

the bottom ventilation grille. Turn the hinge

upside down; position it and screw it on the

opposite side.

Refit the bottom door.

Remove the screws which blank off the holes,

then position the middle hinge on the opposite

side, slightly lifting the doors, making sure that

the doors are properly aligned.

D148

D150

Fig. 1

Fig. 2