Zanussi ZQA12430DV Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Frigorífico Zanussi ZQA12430DV. Zanussi ZQA12430DV 17 páginas.

Zanussi ZQA12430DV Manual do utilizador
Problem
The lamp does not work.
The compressor operates con-
tinually.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products to be fro-
zen were put in at the same
time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Solution
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
9