Zanussi ZR 60/LM Instruções de utilização e cuidados - Página 6
Procurar online ou descarregar pdf Instruções de utilização e cuidados para Frigorífico Zanussi ZR 60/LM. Zanussi ZR 60/LM 8 páginas. Zanussi refrigerators instructions for the use and care
Também para Zanussi ZR 60/LM: Manual de instruções de utilização e cuidados (8 páginas), Manual de instruções de utilização e manutenção (8 páginas)
Imprimir página
c) Slide in the decor panel from the
frameless side, then fasten again the
frame to the door including the previously
removed frame section.
Note
The overall dimensions of the decor panel
should be 1 ± 2 mm smaller than those of
the door, and the thickness should not
exceed 4 mm.
Aligning the worktop with the
kitchen furniture
The appliance is delivered with the
worktop fixed flush with the door.
If a different alignment is required,
proceed as follows (Fig. 2):
Unscrew the screws "c" securing the rear
brackets to the worktop, displace it to
the new location, then secure the screws.
1. - Kitchen unit recess height of 870 mm
The dimensions of the kitchen unit recess,
into which the appliance is to be built-in,
are shown in Fig. 3.
Building the appliance into a
kitchen unit recess
Supplied with the appliance is a kit
including a front venting grille, two
guides and two self-tapping screws.
Fit the two guides as shown in Fig. 4 "a"
on the upper two hinges; to do this,
remove the front screw from these two
hinges by replacing the previously
removed screws with the ones supplied
with the kit;
install the front venting grille and insert
the appliance into the kitchen unit recess.
Installing the appliance under a
kitchen counter
This appliance can also be installed
under a kitchen counter; to prepare it for
this purpose, proceed as follows:
a) Unscrew the screws "c" securing the
rear brackets to the worktop, then slide
it out from slots (8).
b)
Remove foot "b" and replace it with
the adjustable one contained in the
plastic bag together with these
instructions.
In case of difficulties in building in, it is
necessary to remove the two plastic
plugs from the support bracket of the
compressor.
Two building under possibilities
are available and precisely:
1. Kitchen unit recess height 870 mm
2. Kitchen unit recess height 820 mm
6
Fig. 3