Zanussi ZRA40400XA Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Frigorífico Zanussi ZRA40400XA. Zanussi ZRA40400XA 16 páginas.

Zanussi ZRA40400XA Manual do utilizador
mal use. The defrost water drains out through a
drain hole into a special container at the back
of the appliance, over the motor compressor,
where it evaporates.

Troubleshooting

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Problem
The appliance is noisy.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Water flows on the ground. The melting water outlet does not
There is too much frost
and ice.
www.zanussi.com
Possible cause
The appliance is not supported
properly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
flow in the evaporative tray above
the compressor.
Products are not wrapped properly.
The door is not closed correctly.
It is important to peri-
odically clean the de-
frost water drain hole
in the middle of the
refrigerator compart-
ment channel to pre-
vent the water over-
flowing and dripping
onto the food inside.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Check if the appliance stands stable
(all the four feet should be on the
floor).
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to the
evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Solution
7