Zanussi ZRD 18 JB Livro de instruções - Página 6

Procurar online ou descarregar pdf Livro de instruções para Frigorífico Zanussi ZRD 18 JB. Zanussi ZRD 18 JB 18 páginas. Refrigerator- freezer combination

Imprimir página

Avoid opening the door of frozen food compart-

ment during freezing if possible.

It is not expedient to set the termostat knob to high-

er (e.g. "6") position. Freezing time could be

reduced this way, but the temperature of the fresh food

compartment would go beyond 0

would cause freezing to foods and drinks stored there.

Never freeze food in bigger quantity than given

in the "Technical data" at the same time, other-

wise freezing will not be thorough and after dissolv-

ing various deterioration may take place (losing taste

and aroma, lysing, etc.).

Do not make ice during freezing preferably,

bacause making ice reduces freezing capacity.

Storing in the freezer

After finishing freezing it is practical to put the frozen food

from the wire shelf in the frozen food compartment to the

place undar that making room for a next possible freez-

ing. Adjustment of the wire shelf in the frozen food com-

partment ("2" positions) can be used only during storing,

as freezing can be done only at the highest position of the

wire shelf. Food already stored is not damaged by anoth-

er freezing.

(The goods when are put directly on the cooling plate

freeze too fast!)

Do not forget to keep to the storage time given on

the packaging of frozen products if you buy them

frozen.

It is safe to store quick-forzen, frozen foods only if

they have not dissolved even for a short time until

placing them into freezer.

If the deep-frozen food has already dissolved, refreezing

is not recommended, it has to be used as soon as possi-

ble.

How to make ice cubes

To make ice cubes fill the enclosed ice cube tray with

water and put it to the frozen food compartment. Wetting

the bottom of the tray and setting thermostatic control

knob to maximum position can shorten preparing time.

After finishing do not forget to reset the thermostatic con-

trol to the suitable position.

Ready ice cubes can be taken out of the tray under run-

ning water then twist or hit it. If the ice tray freezes to the

compartment, avoid using metal tools or knife to take it

out as the cooling system can be damaged.

Some useful information and

advice

The variable shelves are worth paying attention to,

which increases the usability of the fresh food com-

partment considerably. Rearranging the shelves is

also possible when the door is open at an angle of

90 .

After opening and closing the door of freezer vacuum

will rise inside the appliance because of the low tem-

perature. So wait 2-3 minutes after closing the door

- if you want to open it again - while inner pressure

equalises.

C permanently, which

Take care of operating the freezer at a position of ther-

mostatic control so that the inside temperature can

never be warmer than -18

It is practical to make sure of faultless operation of the

appliance daily so as to notice possible failure in time

and prevent deterioration of frozen foods.

Normal operating sounds:

A thermostat controls the compressor and you

will hear a faint click when thermostat cuts in and

out.

You may hear faint gurgling or bubbling sound

when the refrigerant is pumped thorough the coils

at the rear, to the cooling plate/evaporator.

When the compressor is on, the refrigerant is

being pumped round and you will hear a whirring

sound or pulsating noise from the compressor.

The fridge evaporator (this part cool down the

fridge section) is foamed into the cabinet. The

temperature of this part changing during its work,

and parallel with this its dimensions are slightly

changing, too. These changes might cause a

cracking noise, which is natural, harmless phe-

nomenon.

Should you want to check the temperature of food

stored in the refrigerator, set the thermostat knob into

a medium position, place a glass of water centrally in

the cabinet, and put a proper thermometer with an

accuracy of +/- 1 C into it. If after 6 hours you meas-

ure a value between +3

tor works properly. The measuring shall be performed

under steady-stated conditions (without changing the

load).

If the freezer temperature is measured using a ther-

mometer, put it between the products since this will

reflect the real temperature in the frozen products.

Hints and ideas

In this chapter practical hints and ideas are given about

how to use the appliance to reach maximum energy sav-

ing and there is environmental information about the

appliance as well.

C and +8

C, the refrigera-