Zanussi ZRG614SW Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Frigorífico Zanussi ZRG614SW. Zanussi ZRG614SW 13 páginas.
Também para Zanussi ZRG614SW: Manual do utilizador (16 páginas)
Imprimir página
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow the door to
open enough so that the shelves can be removed.
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
6
Ambient temperature
Levelling
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front (2). If
necessary adjust the feet
by removing the spacer
(1).
Warning!
It must be possible to dis-
connect the appliance from
the mains power supply; the
plug must therefore be easi-
ly accessible after installa-
tion.
To change the opening direction of the door, do these
steps:
1
2