Zanussi ZRT 163W Livro de instruções - Página 9
Procurar online ou descarregar pdf Livro de instruções para Frigorífico Zanussi ZRT 163W. Zanussi ZRT 163W 16 páginas.
Imprimir página
Defrosting Your Appliance
The fridge compartment is defrosted automatically, when
the motor stops. Defrost water from the cooling plate runs
out of the drain and onto a tray on the motor compressor
where it evaporates. Droplets of water on the cooling plate
during defrosting are quite normal and will freeze on the
plate afterwards.
When the appliance is not in use
When the appliance is not in use for long periods discon-
nect from the electricity supply, empty all of the food and
clean the appliance, leaving the door ajar to prevent
unpleasant smells.
If the appliance is not working correctly, please carry out the following checks before contacting your local Zanussi Service
Force Centre.
Problem
No power to the appliance
The temperature in the appli-
ance is too high
The temperature in the appli-
ance is too low
Excessive frost and ice has
built up
The appliance is noisy.
Water under the salad draw-
er.
If after the above checks your appliance still does not
operate correctly, contact your local Service Force
Centre.
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
Something Not Working
Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control knob is set at „0".
The appliance is located in an unsuitable
position.
The thermostat control is set too low.
The thermostat control knob is set too
high.
The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.
The drain hole is blocked.
Check there is power at the socket.
Check there is not a power cut by checking
the household lights.
Check the fuse has not blown.
Check the thermostat control knob setting.
Check the ambient temperature is within
the appliances operating limits of 16 °C to
32 °C.
Check that the thermostat control knob is
turned to the correct setting relative to ambi-
ent conditions.
Set the thermostat control knob to a
warmer position.
Check the door has not been left open.
Check nothing is preventing the door from
closing.
Check the door gasket is intact and clean.
Check if the appliance stands stable (all
four feet should be on the floor).
Check the drain hole is not blocked (see
'Maintenance and Cleaning').
In-guarantee customers should ensure that the
above checks have been made, as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.
Solution
9