Zanussi ZT 154 AO Livro de instruções - Página 9

Procurar online ou descarregar pdf Livro de instruções para Frigorífico Zanussi ZT 154 AO. Zanussi ZT 154 AO 16 páginas.

Imprimir página

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:

Break the circuit of the appliance.

Unscrew the plate screw fixing the lamp cover, then take

the lamp cover off in the direction of arrow and the bulb

can be changed. (Type of the bulb: Mignon 322, 230 V,

15 W, E 14 thread)

Problem

The appliance does not

cool sufficiently

The appliance cools too

hard

The appliance does not

cool at all

The appliance is noisy

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

Change of door opening direction

Should the setting-up place or handling demand it, door-

opening direction can be refitted from right-handed to

left-handed.

Following operations are to be done on the basis of

figures and explanations:

Pull out the plug from the mains socket.

Tilt back the appliance carefully being careful so that

the compressor can not touch the floor. It is

recommended to ask another person for help, who

can keep the appliance at this position safely.

Unscrew the adjustable feet situated on both sides (2

pieces), in addition the screws fixing the lower door

holders (3 pieces) respectively the screw on the

other side.

Put over the pin in the lower door holding plate in the

direction of the arrow.

Possible cause

Thermostatic control is set too low.

Too many foods to be cooled were put in.

Very warm foods were put in.

Door is not shut properly.

There is no inside cool air circulation.

The thermostatic control is set too high.

Plug is not connected to the mains socket

properly.

There is no voltage in the mains socket.

Thermostatic control is in "0" position.

The appliance is not supported properly.

After changing bulb replace the lamp cover, screw the

plate screw and apply voltage to the appliance.

The lack of light does not influence operation of the

refrigerator.

If something does not work

During operation of the appliance some smaller but

annoying trouble can often occur, which does not require

calling a technician out. In the following chart information

is given about them to avoid unnecessary charges on

service.

We draw your attention that operation of appliance goes

with certain sounds (compressor- and circulating sound).

This is not trouble, but means normal operation.

We draw it to your attention again that the

appliance operates discontinuously, so the

stopping of compressor does not mean being no-current.

That is why you must not touch the electrical parts of the

appliance before breaking the circuit.

Set higher position.

Put fewer foods to be cooled.

Put foods max. at room temperature.

Check if the door is shut.

Provide inside cool air circulation.

Set lower position.

Check if the connection is proper.

Check if there is voltage.

Check setting of thermostatic control.

Check if the appliance stands stable (all the four

feet should be on the floor).

Fix the plate on the other side leaving the position of

the door unchanged.

Then screw in the one screw in the place set free on

the other side as well as the adjustable feet (2

pieces) and set up the box.

Solution