Zanussi ZU 7155 Folheto de instruções - Página 8

Procurar online ou descarregar pdf Folheto de instruções para Frigorífico Zanussi ZU 7155. Zanussi ZU 7155 20 páginas. Zanussi instruction refrigerator zu 7155

Imprimir página

DEFROSTING

The refrigerator automatically defrosts every time the

compressor stops. The water is discharged, via the

pipe, into a tray located at the back of the appliance

above the compressor, where it evaporates.

Important

To avoid defrost water overflowing and drip-

ping onto the food in the fridge, periodically

clean the water discharge hole (F) situated

under the vegetable drawers. Use the spe-

cial cleaner provided (P) which you will find

already inserted into the discharge hole

MAINTENANCE AND CLEANING

Before any maintenance or cleaning work is carried

out, DISCONNECT the appliance from the ELEC-

TRICITY supply.

Internal cleaning

Clean the inside and accessories with warm water

and bicarbonate of soda (5ml to 0.5 litre of water).

Rinse and dry thoroughly.

NEVER USE DETERGENTS, ABRASIVE POW-

DERS, HIGHLY PERFUMED CLEANING PROD-

UCTS OR WAX POLISHES, TO CLEAN THE INTE-

RIOR AS THESE WILL DAMAGE THE SURFACE

AND LEAVE A STRONG SMELL.

Clean the drain hole of the water trough at regular

intervals and make sure that the drain hole is never

obstructed, so that the defrost water may flow freely.

Important

Do not use abrasive products.

Periodic cleaning

The appliance is equipped with an air inlet filter (1)

and an air outlet duct (2) on the ventilation grid.

Keep clean to guarantee good ventilation and good

working order of the appliance.

The filter can be removed and washed with water, as

follows:

1. Pinch flaps (a) and (b) with fingers

2. Pull the filter down.

3. Pull the filter out.

To replace the filter reverse the process.

S.I.011

An accumulation of dust will affect the performance

of the appliance and cause excessive electricity con-

sumption.

The structure of the appliance permits to clean the

rear zone close to the wall, using a vacuum cleaner.

1. Remove the plinth (1), then the ventilation grid (2);

2. Carefully pull the air deflector out (3), checking

that there is no water left from the defrosting.

S.I.012

S.I.013