Clarke X-Pro CAT213 Instruções de funcionamento e manutenção - Página 10
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Ferramenta eléctrica Clarke X-Pro CAT213. Clarke X-Pro CAT213 17 páginas. Air nibbler
Imprimir página
the die into the best position required by the workpiece. Hold the die
steady with a spanner on its flats and re-tighten the locknut.
NOTE: The open side of the die should be straight ahead and in
alignment with the metal being cut.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session.
STORAGE
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
When not in use, disconnect from air supply, clean tool and store in a safe, dry
place.
When storing, replace the blanking plug to the air inlet once the airline is
disconnected.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10