Zanussi ZOP37962 Manual do utilizador - Página 20

Procurar online ou descarregar pdf Manual do utilizador para Forno Zanussi ZOP37962. Zanussi ZOP37962 28 páginas.

Imprimir página

and the bars of the heat indicator until

the door unlocks.

To stop Pyrolysis before it is completed,

turn the knob for the oven functions to the

off position.

6. When Pyrolysis is completed, the display

shows the time of day. The oven door stays

locked.

7. When the appliance is cool again, an

acoustic signal sounds and the door

unlocks.

Cleaning reminder

To remind you that the Pyrolysis is necessary,

PYR flashes in the display for 10 seconds after

each activation and deactivation of the

appliance.

The cleaning reminder goes out:

• after the end of the Pyrolysis

function.

• if you press

same time while PYR flashes in

the display.

Cleaning the oven door

The oven door has three glass panels.You can

remove the oven door and the internal glass

panels to clean them.

The oven door can close if you try to

remove the glass panels before you

remove the oven door.

CAUTION!

Do not use the appliance without the

glass panels.

Open the door fully

and hold the two

door hinges.

and

at the

Lift and turn the

levers on the two

hinges.

Close the oven door

halfway to the first

opening position.

Then pull forward and

remove the door from

its seat.

Release the locking

system to remove the

glass panels.

First lift carefully and

then remove the

glass panels one by

one. Start from the

top panel.

Clean the glass panels with water and soap.

Dry the glass panels carefully.

When the cleaning is completed, install the

glass panels and the oven door. Do the above

steps in the opposite sequence.

Make sure that you put the glass panels (A and

B) back in the correct sequence. The middle

panel (B) has a decorative frame. The screen-

printing zone must face the inner side of the

door. Make sure that after the installation the

surface of the glass panel frame (B) on the

Put the door on a soft

cloth on a stable

surface.

90°

Turn the two

fasteners by 90° and

remove them from

their seats.