Zanussi FL402 Folheto de instruções - Página 19

Procurar online ou descarregar pdf Folheto de instruções para Máquina de lavar roupa Zanussi FL402. Zanussi FL402 20 páginas. Washing machine fl 401

Whether discharging into a sink or a standpipe check that

the end of the drain hose is neither too high nor too low.

The top of the curve in the hose's end should be no more

than 90 cm, and no less than 60 cm above floor level.

Should a prolongation of the drain hose be unavoidable

this must never surpass 1.5 m and must be of the same

diameter as the original hose

Important

Before connecting up the machine to new pipework or

to pipework that has not been used for some time, run

off a reasonable amount of water to flush out any debris

that may have collected in the pipes.

Levelling

Level the washing machine by loosening or tightening

the feet. Once in the right position fix the feet by

pushing the nuts against the base of the case

Accurate levelling prevents vibration, noise and

displacement of the machine during operation. After

levelling the machine, secure the feet by tightening the

ring nuts with the aid of a screwdriver.

Some vibration is inevitable, especially if mounted on a

wooden floor.

Sprung wooden floors are particularly susceptible to

vibration. For advice, consult a builder. If possible,

always place the machine on a solid floor.

If the floor is carpeted with a deep-pile carpet or

covered with crumbly or soft material, insert a rigid

support base under the feet to prevent noise, vibration or

displacement. The base should protrude a few

centimetres beyond the edges of the machine.

Warning

The machine should NOT be placed on deep pile

carpeting.

Note

Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a

breakdown.

P1039

P0254

P0509