Zanussi ZWS 688 Manual do utilizador - Página 18

Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa Zanussi ZWS 688. Zanussi ZWS 688 24 páginas.

When the container is full of water, put the

drainage duct back again and empty the con-

tainer. Do steps 3 and 4 again and again until

no more water flows out from the drain pump.

Pull back the drainage duct.

Unscrew the filter and remove it.

Remove fluff and objects from the pump.

Make sure that the impeller of the pump can

turn. If this does not occur, contact the service

centre.

Clean the filter under the water tap and put it

back in the pump into the special guides.

Make sure that you tighten correctly the filter

to prevent leakages.

Close the pump door.

Caution! When the appliance is in use

and depending on the programme selected

there can be hot water in the pump.

Never remove the pump cover during a wash

cycle, always wait until the appliance has

finished the cycle, and is empty. When refitting

the pump cover, ensure it is securely re-

tightened so as to stop leaks and young

children being able to remove it.

Cleaning the water inlet filters

Important! If the appliance doesn't fill, takes

long to fill with water, the starting button blinks

yellow or the display (if available) shows the

relevant alarm (see chapter "What to do if..." for

more details), check if the water inlet filters are

blocked .

To clean the water inlet filters:

• Screw the hose back onto the tap. Make

sure the connection is tight.

• Turn off the water

tap.

• Unscrew the hose

from the tap.

• Clean the filter in

the hose with a stiff

brush.