Zanussi DCE 5655 Folheto de instruções - Página 17
Procurar online ou descarregar pdf Folheto de instruções para Máquina de lavar loiça Zanussi DCE 5655. Zanussi DCE 5655 20 páginas. Zanussi instruction book dishwasher dce 5655
Imprimir páginaInstallation
Positioning
The dishwasher is intended to be installed on a kitchen
sink, worktop or built-in. To function properly, make sure
that the appliance is level. Its height can be adjusted with
the adjustable feets (5 mm each). See the illustration for
built-in measurements.
Water inlet
The dishwasher is equipped with safety features
which are to prevent the water from going back
to the fresh water system. These features are ac-
cording to current water technical safety regulations.
The dishwasher should be permanently plumbed into a
separate cold water supply.
The water pressure must be within the limits given in the
technical specifications, as it will not function correctly if
pressure is outside these specifications.
Your local Water Authority will advise you on the average
mains pressure in your area. Where the water is supplied
from a cold water cistern you can work out the pressure
yourself by measuring the vertical distance (or 'Head')
between the dishwasher's inlet hose and the outlet from
the cold water storage cistern; allowing .86 psi for every 2
feet under normal conditions.
We would advise you to have a shut-off valve or stop-
cock in the water supply pipe close to the dishwasher
and accessible for easy use. This should be turned off
when the appliance is not in use. Insert the combination
rubber washer/filter and connect the inlet hose to a tap
with a 3/4" pipe thread.
The inlet hose must not be joined onto any form of exten-
sion hose. If it is too short, the entire hose must be repla-
ced with a longer high-pressure hose, specially designed
for the purpose. The end of the hose, which is connected
to the dishwasher can be turned in any direction. Loosen
the retaining nut, turn the hose, then retighten the nut.
- 17 -