Zanussi DW 911 Folheto de instruções - Página 5

Procurar online ou descarregar pdf Folheto de instruções para Máquina de lavar loiça Zanussi DW 911. Zanussi DW 911 20 páginas. Zanussi instruction booklet dishwasher dw 911

Imprimir página

Water Outlet Connection

The end of the drain hose can be connected as

follows:

to the sink outlet siphon, securing it if necessary with

a clip;

to a wall outlet provided with vent-hole, minimum

internal diameter 4 cm;

hooked over the edge of the sink using the special

curved plastic guide provided.

The waste connection must be at a height of between

30 cm (minimum) and 100 cm (maximum) from the

floor.

It makes no difference which way the drain hose

faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could

prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer

than 2 metres and its internal diameter must be no

smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used

for connection to the waste outlet must be no smaller

than the diameter of the drain hose.

CS12

Water Supply Connections

This dishwasher must be permanently plumbed into a

cold water supply.

The water pressure must be within the limits given in

the technical specifications, as it will not function

correctly if pressure is outside these specifications.

Your local Water Authority will advise you on the average

mains pressure in your area.

Where the water is supplied via a cold water storage

cistern, you can work out the pressure yourself by mea-

suring the vertical distance (or «head») between the

machine's inlet hose and the outlet from the cold water

storage cistern, allowing roughly 1 psi for every 2 feet.

+ 2 m max

For making the connection itself, the coupling nut

fitted to the machine's supply hose is designed to

screw onto either a 3/4 inch gas thread spout, or to a

purpose made quick-coupling tap such as the Press

Block.

To make this easier, the hose itself may be turned to

the left or the right. In either case, be sure to incorpo-

rate the strainer (A) supplied with the machine into the

joint. See picture.

CA04

Caution: the retaining ring must be correctly fitted to

avoid water leaks.

Note: the end of the hose connected to the machine

can be positioned as required, by simply slackening

the retaining ring.

Re-tighten the ring securely to avoid water leaks.

Avoid bends or kinks in the hose which could prevent

or slow down the flow of water.

If the machine is connected to new pipes or pipes

which have not been used for a long time, you are

advised to run the water for a few minutes before

connecting the inlet hose. This will prevent deposits of

sand or rust clogging the inlet hose filter.

CA06

PIN17GB