Zanussi ZDB310 Folheto de instruções - Página 8

Procurar online ou descarregar pdf Folheto de instruções para Hob Zanussi ZDB310. Zanussi ZDB310 10 páginas. Electric hob zdb310

Imprimir página

Electrical connection

The appliance is designed to be connected to 230 V

monophase electricity supply.

The connection must be carried out in compliance with

the laws and regulations in force.

Before the appliance is connected:

1. check that the main fuse and the domestic installation

can support the load (see the rating label);

2. check that the power supply is properly earthed in

compliance with the current rules;

3. check the socket or the double pole switch used for

the electrical connection can be easily reached with

the appliance built in the forniture unit.

The appliance is supplied with a connection cable. This

has to be provided with a proper plug, able to support the

load marked on the identification plate. The yellow/green

earth wire must be approximately 2 cm. longer than the

phase wires. The plug has to be fitted in a proper socket.

If connecting the appliance directly to the electric system,

it is necessary that you install a double pole switch

between the appliance and the electricity supply, with a

minimum gap of 3 mm. between the switch contacts and

of a type suitable for the required load in compliance with

the current rules.

The connection cable has to be placed in order that, in

each part, it cannot reach a 90 °C temperature.

The brown coloured phase cable (fitted in the terminal

block contact marked with "L") must always be connected

to the live phase.

Replacement of the connection cable

If the connection cable must be replaced, only a type

H05V2V2-F T90 cable must be used. The cable section

must be suitable to the voltage and the working

temperature.

The yellow/green earth wire must be approximately 2

cm. longer than the phase wires (Fig. 8).

To open the terminal block and reach the terminals,

proceed as follows:

1. insert the point of a screwdriver into the visible

protrunding part of the terminal block;

2. exert a light pressure and lift (Fig. 9)

The hob is supplied with a three pole terminal block

designed for a 230 V connection (Fig. 10).

The earth wire must always be connected to the terminal

marked with the symbol

Upon completion, secure the connection cable with the

cable clamp.

Earth wire (yellow/green)

Fig.8

FO 0257

Fig. 9

Fig. 10

Neutral