Zanussi ZEE6940 Manual do utilizador - Página 16

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZEE6940. Zanussi ZEE6940 48 páginas. Product manaul
Também para Zanussi ZEE6940: Manual do utilizador (36 páginas), Manual do utilizador (16 páginas), Manual do utilizador (40 páginas), Manual do utilizador (12 páginas)

Imprimir página

• Installation and connection of the ap-

pliance to the power supply must only

be done by qualified personnel.

• Only use built-in appliances after you assem-

ble the appliance into correct built-in units

and work surfaces that obey the standards.

• Do not change the specifications or modify

this product. There is a risk of injury or dam-

age to the appliance.

• Fully obey the laws, ordinances, directives

and standards in force in the country where

you use the appliance (safety regulations, re-

cycling regulations, electrical safety rules

etc.).

• Keep the minimum distances to other appli-

ances and units.

• Install anti-shock protection, for example in-

stall the drawers only with a protective panel

directly below the appliance.

• If the fixing bracket is near to the terminal

block, always make sure the connection ca-

ble does not come in contact with the edge

of the bracket.

• Prevent damage of the cut surfaces of the

worktop against moisture with a correct seal-

ant!

• Seal the appliance to the worktop with no

space left with a correct sealant.

• Prevent damage of the bottom of the appli-

ance from steam and moisture, e.g. from a

dishwasher or oven.

• Do not install the appliance adjacent to

doors and below windows. Hot cookware

can be hit off the hob when you open doors

or windows.

• Disconnect the appliance from the elec-

trical supply, before you do mainte-

nance work or cleaning.

Warning! Risk of injury from electrical

current. Carefully obey the instructions for

electrical connections.

• The electrical mains terminal is live.

• Make the electrical mains terminal free of

voltage.

• Install correctly to give anti-shock protection.

• Loose and incorrect mains plug and socket

connections can make the terminal become

too hot.

• A qualified electrician must install the clamp-

ing connections correctly.

• Use a strain relief clamp on cable.

• Use the correct mains connection cable and

replace the damaged mains cable with the

proper cable type. Speak to your local Serv-

ice Centre.

The appliance must have the electrical installa-

tion which lets you disconnect the appliance

from the mains at all poles with a contact open-

ing width of minimum 3 mm. You must have

correct isolation devices: line protecting cut-

outs, fuses (screw type fuses removed from the

holder), ground leakage trips and contactors.

The manufacturer is not responsible for

any injury to persons and pets or damage

to property caused by failure to obey

these requirements.

Electrical connection

• Ground the appliance according to safety

precautions.

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• The appliance is fitted with a five pole termi-

nal box whose cables are predisposed for

230 V monophase function.

3 4 5

In case of different voltage, carry out the

connection as shown in connection sche-

matic table on the lower protection.

• Any electrical component must be installed

or replaced by the Service Force Centre

technician or qualified service personnel.

• Always use a correctly installed shockproof

socket.