Zanussi ZEI6640FBA Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZEI6640FBA. Zanussi ZEI6640FBA 36 páginas.

Imprimir página

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate
the hob.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
Automatic Heat Up function does
not operate.
The heat setting changes be-
tween two levels.
The sensor fields become hot.
comes on.
www.zanussi.com
Possible cause
The hob is not connected to an
electrical supply or it is connec-
ted incorrectly.
The fuse is released.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on the
control panel.
You put something on one or
more sensor fields.
You put something on the sensor
field
.
The zone is not hot because it
operated only for a short time.
The zone is hot.
The highest heat setting is set.
Power management function op-
erates.
The cookware is too large or you
put it too near to the controls.
Automatic Switch Off operates.
Remedy
Check if the hob is correctly con-
nected to the electrical supply.
Refer to the connection diagram.
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Activate the hob again and set
the heat setting in less than 10
seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sen-
sor fields.
Remove the object from the sen-
sor field.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Let the zone become sufficiently
cool.
The highest heat setting has the
same power as the function.
Refer to "Daily use" chapter.
Put large cookware on the rear
zones if possible.
Deactivate the hob and activate it
again.
11