Zanussi ZES3921 Manual do utilizador - Página 12

Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZES3921. Zanussi ZES3921 44 páginas. Product manaul
Também para Zanussi ZES3921: Manual do utilizador (40 páginas)

Imprimir página

Warning! The appliance must be earthed.

Electrical connection

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug (if

applicable).

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree

with the latest I.E.E. Regulations and local Elec-

tricity Board regulations. For your own safety

the installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National In-

spection Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer refuses to be held re-

sponsible, if these safety measures are not

abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an effi-

cient earth connection in compliance with

the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

power cable requiring a 3 amp plug. You must

purchase and install the plug.

The wires in the cord are coloured as follows:

Green and yellow

Blue

Brown

Replacement of the connection cable

1. Connect the green and yellow (earth) wire

to the terminal in the plug which is marked

with the letter 'E', or the earth symbol

or coloured green and yellow.

2. Connect the blue (neutral) wire to the ter-

minal in the plug which is marked with the

letter 'N' or coloured blue.

3. Connect the brown (live) wire to the termi-

nal in the plug which is marked with the let-

ter 'L' and is always connected to the net-

work phase.

There must be no cut or stray strands of wire

present. The cord clamp must be correctly at-

tached to the outer sheath.

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to the

voltage and the working temperature. The yel-

low/green earth wire (B) must be approximately

2 cm longer than the live and neutral wire (A).

- Earth

- Neutral

- Live