Zanussi ZGF 642 CTN Folheto de instruções - Página 5

Procurar online ou descarregar pdf Folheto de instruções para Hob Zanussi ZGF 642 CTN. Zanussi ZGF 642 CTN 16 páginas. Gas hobs

Imprimir página

Maintenance and Cleaning

Before any maintenance or cleaning can be

carried out, you must DISCONNECT the hob

from the electricity supply.

The hob is best cleaned whilst it is still warm, as spillage

can be removed more easily than if it is left to cool.

The Hob Top

Regularly wipe over the hob top using a soft cloth well

wrung out in warm water to which a little washing up

liquid has been added. Avoid the use of the following:

household detergent and bleaches;

impregnated pads unsuitable for non-stick

saucepans;

steel wool pads;

bath/sink stain removers.

Should the hob top become heavily soiled, the following

products are recommended:

- For stainless steel hobs use a proprietary stainless

steel cleaner.

- For other hobs use Hob Brite or Bar Keepers Friend.

Cast Iron Pan Supports

The hob has cast iron pan supports.

Take care when removing them. They are very heavy and

could damage the hob or your kitchen furniture if you let

them fall down.

To keep the pan supports in the correct position, they

are hooked into hinges at the back of the hob. When

removing the pan supports, lift them up as shown in the

diagram. Never turn the pan supports on the hinges, this

could damage them.

Wash the pan supports using hot soapy water. If

necessary, a paste cleaner or a soap impregnated steel

wool pad can be used with caution.

After cleaning, be sure to wipe dry with a soft cloth.

The Burners

The burner caps and crowns can be removed for cleaning.

Wash the burner caps and crowns using hot soapy water,

and remove marks with a mild paste cleaner. A well

moistened soap impregnated steel wool pad can be used

with caution, if the marks are particularly difficult to remove.

After cleaning, be sure to wipe dry with a soft cloth.

Ignition electrode

The electric ignition is obtained through a ceramic

"electrode" and a metal electrode (see diagram on page

4 - letter C). Keep these components very clean, to avoid

lighting difficulties, and check that the burner crown

holes are not obstructed.

YES