Zanussi ZGF 6420 Folheto de instruções - Página 4

Procurar online ou descarregar pdf Folheto de instruções para Hob Zanussi ZGF 6420. Zanussi ZGF 6420 16 páginas.

Imprimir página

Operation

Hob Burners

To light a burner:

push in the relevant control knob and turn it

anticlockwise to maximum position;

then adjust the flame as required.

If the burner does not ignite, turn the control knob to

zero, and try again.

In the absence of electricity, ignition can occur without

the electrical device; in this case approach the burner

with a flame, push the relevant knob down and turn it

anti-clockwise until it reaches maximum position.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

Burner

Large (rapid)

Medium (semi-rapid)

Small (auxiliary)

If you use a saucepan which is smaller than

the recommended size, the flame will spread

beyond the bottom of the vessel, causing the

handle to overheat.

Take care when frying food in hot oil or fat,

as the overheated splashes could easily

ignite.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

If the control knobs become difficult to turn, please

contact your local Service Force Centre.

Maintenance and Cleaning

Before any maintenance or cleaning can be carried

out, you must DISCONNECT the hob from the

electricity supply.

The hob is best cleaned whilst it is still warm, as spillage

can be removed more easily than if it is left to cool.

The Hob Top

Regularly wipe over the hob top using a soft cloth well

wrung out in warm water to which a little washing up

liquid has been added. Avoid the use of the following:

household detergent and bleaches;

impregnated pads unsuitable for non-stick

saucepans;

steel wool pads;

bath/sink stain removers.

Should the hob top become heavily soiled, it is

recommended that a cleaning product such as Hob Brite

or Bar Keepers Friend is used.

minimum

maximum

diameter

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm

A - Burner cap

B - Burner crown

C - Ignition electrode

Fig. 1