Zanussi ZGF 692 C Folheto de instruções - Página 7

Procurar online ou descarregar pdf Folheto de instruções para Hob Zanussi ZGF 692 C. Zanussi ZGF 692 C 32 páginas. Zanussi instruction booklet gas hob zgf 682, zgf 692
Também para Zanussi ZGF 692 C: Folheto de instruções (16 páginas)

Imprimir página

Instructions for the User

INSTALLATION

Any gas installation must be carried out by a registered

competent person, and in accordance with existing rules and

regulations.

The relevant instructions are to be found in the second section of this

manual.

Please, ensure that, once the hob is installed, it is easily accessible for

the engineer in the event of a breakdown.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to remove any protective

materials, which were put on in the factory.

The manufacturer will not accept liability, should the above instructions or

any of the other safety instructions incorporated in this book be ignored.

Operation

Lighting the burners

For easier lighting,

a pan on the pan support.

To light a burner:

turn the relevant knob anti-clockwise to maximum

position (

burner.

Only for model ZGF 692 CT

Upon ignition, keep the knob pushed down

about 5 seconds

5 seconds

5 seconds. This will allow the

5 seconds

"thermocouple" (Fig. 1 - letter D) to be heated

and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control knob

to zero, and try again.

If you cannot light the flame even after

severalattempts, check the "cap" (Fig. - lett. A A A A A )

and the"crown" (Fig. - lett. B B B B B ) are in the correct

position.

proceed before putting

), then push it down to ignite the

Triple crown burner

(mod. ZGF 692 C/CT)

A A A A A - Burner cap

B B B B B - Burner crown

C C C C C - Ignition electrode

D D D D D - Thermocouple (only in

)

model ZGF 692 CT