Zanussi ZGG 642 Folheto de instruções - Página 9

Procurar online ou descarregar pdf Folheto de instruções para Hob Zanussi ZGG 642. Zanussi ZGG 642 20 páginas. Gas hobs
Também para Zanussi ZGG 642: Folheto de instruções (16 páginas), Folheto de instruções (20 páginas), Folheto de instruções (16 páginas), Folheto de instruções (16 páginas), Folheto de instruções (16 páginas), Folheto de instruções (16 páginas)

Installation

IMPORTANT

This hob must be installed by a competent and

qualified person only.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this book be ignored.

Gas Connection

Connection to the gas supply should be with either rigid

or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to RC

1/2 (1/2 BSP male thread).

When the final connection has been made, it is essential

that a thorough leak test is carried out on the hob and

installation. Ensure that the main connection pipe does

not exert any strain on the hob.

It is important to install the elbow correctly, with

the shoulder on the end of the thread, fitted to the

hob connecting pipe.

Failure to ensure the correct assembly will cause

leakage of gas.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important

to remove any protective materials, which were

put on in the factory.

On the end of the shaft, which includes the GJ 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using excessive

force.

Cut Out Size

The dimensions of the cut-out are given in the diagram.

FO 0264

FO 2098

Rectangular cut-out size for hob

Dimensions are given in mm.

FO 0814

A)End of shaft with nut

B) Washer

C) Elbow