Zanussi ZGG35214 Manual do utilizador - Página 7
Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZGG35214. Zanussi ZGG35214 16 páginas.
Também para Zanussi ZGG35214: Manual do utilizador (28 páginas), Manual do utilizador (16 páginas), Manual do utilizador (20 páginas)
Imprimir página
There must be no cut or stray strands of wire
present. The cord clamp must be correctly at-
tached on the outer sheath.
Warning! Make sure that the cut off plug
is disposed of safely. A cut off plug put
into a 13 amp socket is a safety hazard. There
is a risk of electrical shock.
Important! The replacement of the electrical
cable must be done by a qualified electrician or
competent person, according to the current
regulations.
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make sure
that the cable section is applicable to the volt-
age and the working temperature. The yellow/
green earth wire must be approximately 2 cm
longer than the brown (or black) phase wire.
Assembly
min. 600 mm
min. 650 mm
40-50 mm
55 mm
If several 30 cm hobs are to be installed side by
side into the same cut out, an assembly kit in-
cluding a support side bracket and supplemen-
tary seals is available at our Service Centres.
The relevant installation instructions are sup-
plied within the kit package.
www.zanussi.com
A) supplied seal
B) supplied brackets
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be easy
to remove and let an easy access in case a
technical assistance intervention is necessary.
60 mm
490 mm
270 mm
a) Removable panel
b) Space for connections
Kitchen unit with oven
The hob recess dimensions must obey the indi-
cation and the kitchen unit must be equipped
with vents to let a continuous supply of air. The
electrical connection of the hob and the oven
must be installed separately for safety reasons
and to let easy remove oven from the unit.
B
30 mm
a
min 20 mm
(max 150 mm)
b
2
50 cm
2
360 cm
A
2
120 cm
180 cm 2
7